|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
5-2
CK100-M CKBUF-M
DNI
4 3 2 1
D
5 Schematic Diagrams and PCB Silkscreen
5-1-1(a) Main Board Schematic Sheet 2 of 26(Clock Chip)
C
B
1) Don't place Clock chip edge. Place near PCB center and mounting hole.
Make the clock generator area more "clean"
2) Every power pins have a decoupling CAP direct connect it.
Make the shortest trace.
3) Ground pin directly connect to ground plane.
4) Make trace power ground pin short and wider than width of chip pad.
5) Don't place via between clock chip power pin and decoupling CAP.
6) Clock trace must have damping resistor and filter Capacitor near to clock chip output pin.
A
7) No other signal trace across through the clock generator area.
Including crystal, clock chip, decoupling capacitor, damping and filter.
S820/S850
4 3 2 1
|
|
|
> |
|
