|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
reasonable price for the schematic - the service is perfect, all as expected and pointed by instructions - good scan of the original plans - thank you!
;
Manual was just as described!!! I odered it and in less than a day was able to download it and the text was clear and pages were all complete just as the original manual was. Purcashed this for a friend and they were more than happy. Perfect all around!
 ;
Excellent service and prompt delivery. But it's not a manual - only 4 pages wiring diagrams.
Thanks.
;
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
;
Il download del Service Manual JVC HR 4100 non é stato eseguito
NOTE When reassembling speakers be sure to connect the speaker wires to the correct speaker lead (+) (-)
9.1. Disassembly for CRT replacement 1. Discharge the CRT as instructed in the �safety precautions�. 2. Disconnect the yoke (DY) plug, degaussing coil (DEG) plug from the main board. 3. Unplug the CRT 2nd anode button from the main board. 4. Remove the C-Board from the CRT base and unplug the black wires (CRT dag ground) C10 & C11. 5. Disconnect the speakers plug from the A-Board. 6. Lift the main chassis (A-Board) and all mounted boards completely out with the CRT board attached. 7. Perform complete removal of chassis, as instructed in �disassembly for service� section.
CRT replacement
1. Perform �disassembly for CRT replacement� procedure. 2. Insure that the CRT H.V. Anode button is discharged before handling the CRT. Read the �safety precautions� section on handling the picture tube. 3. Remove the components from the CRT neck and place the cabinet face down on a soft pad. 4. Note the original order for the CRT mounting hardware as they are remove from the CRT mounting brackets at each corner of the CRT. 5. Remove the CRT with the degaussing coil and the dag ground braid attached. 6. Note the original locations and mounting of the degaussing coil and the dag ground assembly to insure proper reinstallation on the replacement CRT.
18
|
|
|
> |
|
