|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
NC100RD.OM.QXD
9/13/02
1:09 PM
Page 4
PREPARATION FOR USE (CONTINUED)
Battery Operation
The battery compartment is located on the bottom of the unit. � Remove the battery compartment door by sliding it out as shown in Figure 1 below. � Insert eight (8) �C� size batteries into the battery compartment as shown in Figure 2 below. Be sure to observe the polarity markings which are engraved inside the battery compartment. If the batteries are inserted incorrectly, the unit will not operate. � Replace the battery compartment door. NOTE: The AC power cord must be disconnected from the AC socket on the bottom of the unit in order for the unit to operate on battery power.
+ +
Figure 1
-+ -+ -+
Figure 2
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries speci�ed. 2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. 3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones. 4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer�s directions.)
HEADPHONE JACK
For private listening, connect low impedance (32 ohm) 3.5 mm stereo headphones (not included) to this jack. The unit�s speakers are automatically disconnected when the headphone plug is inserted into the jack.
4
+ + -
-+
-
|
|
|
> |
|
