Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Text excerpt from page 13 (click to view)
GAS EQUIPMENT ASSEMBLY
SOLENOID VALVE THERMOCOUPLE BURNER MOUNTING SCREWS
FIG. 12 BURNER TUBE .
INLET FITTING BURNER JET SPARK ELECTRODE MANUAL SHUTOFF VALVE Shown in open position PRESSURE TEST PORT
E.
1. 2. 3. 4. 5. 6. 7.
8. 9.
The correct operating pressure is 11 inches of water column. The correct place to take the LP gas pressure is at the test port just ahead of the burner jet. (See FIG. 12). Inspect the flue baffle. It should be reasonably clean and free of soot. Heavy soot formation indicates improper functioning of the burner. The flue and burner both require cleaning in the following manner: Unplug the refrigerator power cord from the 120 volt AC outlet. (See FIG. 3). Disconnect or shut off the 12 volt power to the refrigerator. Turn manual shutoff valve to OFF. (See FIG. 1). Remove cover from the burner housing. (See FIG. 1). Disconnect the wire from the high voltage electrode. Remove the burner mounting screws and remove the burner assembly. (See FIG. 12). Remove the wire and the flue baffle from the top of flue tube. Clean the flue from the top using a flue brush. Blowing compressed air into the flue will not properly clean soot and scale out of the flue tube. Replace the flue baffle. Clean burner tube with a brush. Blow out burner with compressed air. Before removing burner jet, clean burner area of soot and scale that fell out of flue tube. Remove the burner jet. Soak the jet in wood alcohol and blow it out with compressed air. Reinstall and tighten burner jet. NOTE: The color of the flame shall be clear blue over the slots of the burner. (See FIG. 13). Clear blue color of flame
! WARNING
DO NOT use a wire or pin when cleaning the burner This can cause damage to the refrigerator or create a fire hazard. jet as damage can occur to the precision opening.
10. Reinstall burner, being careful that the end of the burner fits into the slot on the burner bracket. Check to make sure slots are centered under the flue tube 11. Be sure to reconnect the wire to high voltage elecand the thermocouple is positioned properly (tip of thermocouple extends over two slots of burner). trode. Check the electrode for proper location and gap. (See FIG. 14). Electrode
FIG. 14
1/8� to 3/16� (3-5 mm) Burner tube 12. Turn on manual gas shutoff valve and check all fittings for leaks. 13. Connect 120 volt power cord to the outlet and reconnect or turn on the 12 volt DC power. 14. Check LP gas safety shutoff. See page 6.
