|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
 ;
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
;
Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
NN-CS597S
10. Remove 1 screw holding thermistor on heater DU.
6.10. Bake fan motor and bake heater
1. Remove 6 screws and then move over rear cover.
11. Remove 6 screws holding heater DU & thermal cutout bracket on the bottom of oven assy. To install heater DU NOTE: 1.Spread silicon grease evenly between the interface of heater DU and bottom of oven cavity. (about 0.3mm thickness), this is for good conductibility. 2.Tighten 6 screws and make sure there is no gap between heater DU and bottom of oven cavity. 3.Do not forget to screw the thermal cutout bracket along with heater DU. To install thermistor NOTE: Before installing thermistor, please fill enough silicon grease into the installation hole of heater DU for good conductibility. 2. Disconnect 2 lead wires from the harness of noise filter (U), which are connected to both "Neutral" and "live" lead wire of oven circuit breaker.(black and white housing connectors) 3. Disconnect 2 lead wires from oven circuit breaker harness connecting to main lead wire harness. (blue and yellow housing connectors) 4. Remove 1 screw holding side cover on cavity back plate.
19
|
|
|
> |
|
