|
Who's Online
There currently are 5608 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
Note: a and c are the dimensions from each edge.
7. Installing 15mm (0.6�)
the Thermoswitch
Confirm that the sensor surface of the thermoswitch is touching the surface of the upper fixing roller evenly. For reference: There is no need to adjust the position of the thermoswitch. If the thermistor is not touching the upper fixing roller evenly, check if the thermoswitch spring is deformed.
Table 4-1 a. Measuring the nip width If the rollers are cool, wait 15 minutes beyond when the copy START indicator begins glowing green, make 20 copies, then measure the nip width. b. Measuring procedure 1) Raise the copyboard cover and make an A3 Ledger size solid black copy. 2) When the leading edge of the copy paper first appears at the delivery port, set the power switch OFF, and open the front door and the paper delivery unit. 3) Turn the fixing unit knob very slightly counterclockwise stop it in that position for 15 seconds, then turn the knob again to deliver the paper completely. 4) Measure the width of the toner area with a glossy surface, as shown in Figure 4-85. 6. Installing the Thermistor Figure 4-87
Thermoswitch
Confirm that the sensor surface of the thermistor is touching the surface of the upper fixing roller evenly. For reference: There is no need to adjust the position of the thermistor. If the thermistor is not touching the upper fixing roller evenly, check if the thermistor spring is deformed.
_-
Figure 4-88
COPYRIGHT 1980CANONINC. 0
CANONNP-1318/1210 SEPT. RN.0 1900PAlWTEO JAPANIlMPAlMf JAPOAI IW AU
4 - 27
$4.99 NP1218 CANON Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|