|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
,.-.._
B. Scanner Drive Assembly
1. Routing the Mirror Drive Cable 1) Loosen the two fixing screws shown in Figure
4-205. 2) Turn the adjusting screw to move the pulley@ to the right. 3) Move the No. 1 and No. 2 mirror mounts fully to the front. 4) Route the cable with the numbered order provided in Figure 4-205. at number lead the cable at the bottom @, of the pulley. at number g:, wind the cable five times clockwise from bottom to top.
at number @I,,lead cable at the top of the pulley. 5) Adjust the tension of the cable; see �Adjusting the Tension of the Mirror cable:� 6) Adjust the position of the mirror; see �Adjusting the Position of the Mirror.�
2.
Adjusting the Tension of the Mirror Drive Cable
To adjust the tension of the mirror drive cable, loosen the fixing screw, and turn the adjusting screw to change the position of the pulley 0. Set the No.1 mirror mount on the home position side, and pull a point between 0 and @ with a spring gauge; Figure 4-205. Make adjustments so that the reading of the gauge is 800 to 900 g when the cable is pulled to the front of the machine by 20 mm.
No.2 mirror mount
No.1 mirror mount
\
Scanner motor
Adjusting screw
Figure 4-205
,/- \
COPVRlGNl CANON INC. 0 l@i
CANON NP305013WO 1991 REV.1 OCT. PWED JAPAN AU IN (IMPRUE JAK�N)
4-9
 $4.99 NP3030 CANON
Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|
