|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
 ;
helpful manual.good service.Quick response.will use again
;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
T-BASS l-r
\ I
�.r. � B
SHIFT
T-BASS
VOLUME
Au
This unit provides the following three different equalization ROCK: Powerful sound emphasizing treble and bass POP: More presence in the vocals and midrange CLASSIC: Enriched curves.
Turn VOLUME on the main unit, or press VOLUME on the remote control.
The volume level is displayed as a number from O to MAX (31). The volume level is automatically set to 16 when the power is turned off with the volume level set to 17 or more.
sound with heavy bass and fine treble.
Press one of GRAPHIC
The selected equalization
EQUALIZER.
mode is displayed.
The T-BASS sound.
system
enhances
the realism
of low-frequency
To cancel the selected Press the selected
mode
is displayed.
Press T-BASS.
Each time it is pressed, the level changes. Select one of the three levels, or the off position to suit your preference.
button again. �GEQ OFF
To select with the remote control Press GEQ repeatedly while pressing SHIFT. The GEQ mode is
displayed cyclically ROCK� as follows. POP � CLASSIC� GEQ OFF � (cancel)
r
7
To select with the remote control press T-BASS while pressing SHIFT.
m
Low frequency sound may be distorted when the T-BASS system is used for a disc or tape in which low frequency sound is originally emphasized. In this case, cancel the T-BASS system.
To dim the illumination
of the display
Using the headphones
Connect headphones to the PHONES jack with a standard stereo plug (06.3 mm, �/4 inch). No sound is output from the speakers while the headphones are plugged in.
1
2
Press CLOCK/DIMMER twice so that �DIMMER� is displayed, then press II SET within 4 seconds. Press ++ or repeatedly to select the dimmer mode as follows. DIMMER 1� DIMMER 2� DIM-OFF (cancel)
Sound adjustment
during recording
or headphones may affecting the recording.
The output volume and tone of the speakers 3 Press II SET within 4 seconds. DIMMER 1: The illumination of usual, and the spectrum analyzer DIMMER 2: The illumination of DIMMER 1, and the illumination DIM-OFF: The normal display is be freely varied without the display is dimmer than lights off. the display is dimmer than on the buttons light off. resumed.
ENGLISH
16
|
|
|
> |
|
