|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
 ;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
ECO mode
Reduces power consumption with the following operations, etc.
- The unit blacks out when the unit is turned off. Only the red indicator lights up. (Only when the clock is set.) - If dimmer mode is set to on, the unit illumination brightens (for 10 seconds) only when you operate the unit.
Dimmer
Adjusts the brightness of the display.
1 Press DEMO/ECO twice when the unit is turned on, and then within 4 seconds press ENTER. 2 Turn MULTI JOG to select one of the three dimmer modes or "DIM-OFF", and then press ENTER.
"DIM-OFF" is the brightest and "DIMMER 3" is the dimmest. If there is no MULTI JOG or button operation within 4 seconds, the setting is canceled. To cancel the dimmer Repeat the above and select "DIM-OFF".
Setting the clock
1 Press SHIFT+CLOCK on the remote control.
When the unit is turned off, you can also press aSET.
2 Press f or g to set the time.
Each press changes the time in 1-minute steps. Holding it down changes the time in 10-minute steps. If f or g is not pressed within 4 seconds, the setting is canceled. �MULTI JOG is also available in place of f or g.
En
1 Press DEMO/ECO once when the unit is turned on, and then within 4 seconds press ENTER. 2 Turn MULTI JOG to select "ECO ON" and then press ENTER.
3 Press ENTER or aSET.
The time display stops flashing and the clock starts from 00 seconds. To display the time Press SHIFT+CLOCK on the remote control. The time will be displayed for 4 seconds, but it cannot be displayed during recording. To switch to the 24-hour standard Display the time and press s within 4 seconds. With each press, the clock alternates between the 12-hour standard and the 24-hour standard.
If there is no MULTI JOG or button operation within 4 seconds, the setting is canceled.
To cancel the ECO mode Repeat the above and select "ECO OFF".
Tip: In the 12-hour standard, "AM 12:00" indicates midnight and "PM 12:00" noon.
If the clock display flashes when the unit is turned off There has been a power interruption. Re-set the clock.
9
 $4.99 NSXD30 AIWA
Service Manual Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…
|
|
|
> |
|
