|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
Note:
The tape material itself is the same in both types.
2.4. SELF-DIAGNOSIS RESULT DISPLAY
The "SELF-DIAGNOSIS RESULT DISPLAY & MEMORY function is built in this VTR. It means that when the VCR detects undesirable condition, it can be displayed a �Error code (Two numbers from the left)� with Service Mode 2. Since the "Error code" is stored in the EEPROM, it can be displayed although after disconnected the AC leads. It can be displayed with Service Mode 2. (If a second error had been detected, only the most recent error is displayed. ) For more details, refer to the Service Manual for Z-Mechanism Chassis Order number VRD9612M129.
INDICATION CAUSE 01 After cylinder lock is detected, the cylinder does not start rotating again even after tape unloading. 02 Cassette tape is not wound up during the tape unloading except EJECT mode. 03 Mechanism locks during mode transition except EJECT mode. 04 06 07 Mechanism locks during tape unloading. Mechanism locks after tape unloading in EJECT mode. During recording mode, recording signal is less than the normal condition. Recording circuit works except recording mode. Cylinder lock detection. Supply reel mechanism lock detection Take-up reel mechanism lock detection PG shifter automatic adjustment error.
REMEDY/CHECK Check the cylinder motor drive circuit. Check the capstan motor drive circuit.
1. Check the loading motor drive circuit. 2. Check the mechanism phase alignment. 3. Check the mode switch. 1. Check the loading motor drive circuit. 2. Check the mechanism phase alignment. 1. Check the loading motor drive circuit. 2. Check the mechanism phase alignment for cassette holder un
08 16 17 18 2*
Protection of the over-current flowing in transis which produces the power supply for recording mode. Check the recording circuit. Check the cylinder unit and the cylinder motor drive circuit. Check the supply reel mechanism and the sup reel circuit. Check the Take-up reel mechanism and the Take-up reel circuit. Check the servo/system control circuit and the cylinder unit.
Fig. T1 Self-Test indication Display
2.5. CAUTION FOR AC MAINS LEAD (NV-FJ620B/BL)
http://cxema.ru
|
|
|
> |
|
