This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Text excerpt from page 12 (click to view)
Before Use
The Grip Belt
ª To Use as a Grip Belt
Adjust the length of the Grip Belt to the size of your hand. 1 Detach the end of the Grip Belt.
�When you are not recording, be sure to cover the Lens with the Lens Cap for protection. 2
1
2
2 Adjust the length of the Grip Belt to the size
of your hand.
�When you remove the Lens Cap, press the knobs firmly.
3 Reattach the Grip Belt.
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap before going out of doors to record so as to avoid dropping the Movie Camera. 1 Pull the end of the Shoulder Strap through the Shoulder Strap Holder on the Movie Camera.
Re-attaching the Lens Cap
To protect the Lens surface, attach the Lens Cap. 1 The Lens Cap and Lens Cap Cord comes preattached to the Grip Belt.
2 Fold the end of the Shoulder Strap, run it
through the Shoulder Strap Length Adjuster, and pull it. �Pull it out more than 2 cm 1 from the Shoulder Strap Length Adjuster so that it cannot slip off.
2 Pass the end of the Lens Cap Cord through
the attached eye on the Lens Cap. Then pass the Lens Cap through the loop made by itself and pull tight.
1
�Attach the other end of the Shoulder Strap to the other Shoulder Strap Holder in the same way. �When not using the Lens Cap, pull the Lens Cap Cord in the direction of the arrow. 1
