|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
 ;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
Before Use
ª To Use as a Hand Strap
Using the Grip Belt as the hand strap makes it easier to handle and carry the Movie Camera. It is more convenient to use with the Free Style Remote Controller with Mic.
2 Pass the end of the Lens Cap Cord through
the hole in the Grip Belt Attachment part and the Lens Cap through the Lens Cap Cord.
1 Open the Lock Cover (15) by holding the
tabs on both sides 1, press the Lock Button (14) and detach the Grip Belt.
�The removed Lens Cap can be hooked onto the Grip Belt. (It is not possible when using as a hand strap.) �When you are not recording, be sure to keep the Lens Cap attached to the Lens for protection.
(15)
1
(14)
2 Slide the pad of the Grip Belt.
Attaching the Shoulder Strap
3 Attach the Grip Belt around your wrist.
We recommend that you attach the Shoulder Strap before going out of doors to record so as to avoid dropping the Movie Camera. 1 Pull the end of the Shoulder Strap through the Shoulder Strap Holder on the Movie Camera.
�When putting the Grip Belt back to the Grip Belt Attachment part, press on the Lock Cover 2 to be securely locked.
2 Fold the tip of the Shoulder Strap, run it
2
through the Shoulder Strap Length Adjuster, and pull it. �Pull it out more than 2 cm 1 from the Shoulder Strap Length Adjuster so that it cannot slip off.
Attaching the Lens Cap
To protect the Lens surface, attach the Lens Cap. 1 Pass one end of the Lens Cap Cord through the attached eye on the Lens Cap. Then pass the other end through the loop made by itself and pull tight.
1
�Attach the other end of the Shoulder Strap to the other Shoulder Strap Holder as the same way.
-11-
|
|
|
> |
|
