|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
 ;
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
;
Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
Resource Mapping
The PIIX4E PCI-to-ISA bridge has four programmable interrupt request (PIRQ) input signals. Any PCI interrupt source (either onboard or from a PCI add-in board) connects to one of these PIRQ signals. Because there are only four signals, some PCI interrupt sources are mechanically tied together on the motherboard and therefore share the same interrupt. Table 37 lists the PIRQ signals and shows how the signals are connected to the onboard PCI interrupt sources.
Table 37. PCI Interrupt Routing Map
First PCI Expansion Slot: J4C1 INTA INTB INTC INTD Second PCI Expansion Slot: J4B1 INTB INTC INTD INTA Third PCI Expansion Slot: J4A3 INTC INTD INTA INTB INTD INTC AGP Video PCI Audio Power Management INTA
PIIX4E PIRQ Signal PIRQA PIRQB PIRQC PIRQD
USB INTA
For example, assume an add-in board has one interrupt (group INTA) and is plugged into the second PCI slot. In this slot, an interrupt source from group INTA connects to the PIRQB signal. This add-in board will not share an interrupt. Now, however, plug an add-in board that has one interrupt (group INTA) into the first PCI slot. Plug a second add-in board that has two interrupts (groups INTA and INTB) into the second PCI slot. INTA in the first slot is connected to signal PIRQA. INTA in the second slot is connected to signal PIRQB, and INTB is connected to signal PIRQC, which is already connected to the onboard audio. The second interrupt source on the add-in board in the second PCI slot will share an interrupt with the onboard audio.
NOTE
The PIIX4E can connect each PIRQ line internally to one of the IRQ signals (3, 4, 5, 7, 9, 11, 14, 15). Typically, a device that does not share a PIRQ line will have a unique interrupt. However, in certain interrupt-constrained situations, it is possible for two or more of the PIRQ lines to be connected to the same IRQ signal.
53
|
|
|
> |
|
