SATRAP OECOPLAN 67 KS
Owner's Manual

GB

Regular cleaning

It is recommended to wash the inside of the refrigerator in 3-4 weeks time. Household cleaner or soap must not be used. After you made it no-current wash the appliance using lukewarm water and wipe it. Clean the magnet door rubber profile with clean water. After cleaning plug the appliance to the mains socket. It is practical to clean and defrost the ice-making compartment at a time and when it is empty. Dust and dirt collected on the back of the refrigerator, condenser is recommended to be removed once or twice a year.

Trouble shooting
During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This is not trouble, but means normal operation. We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being nocurrent. That is why you must not touch the electrical parts of the appliance before breaking the circuit.

When the refrigerator is not in use
In case the appliance will not be used for a long time follow these steps: Break the circuit of the appliance. Remove foods from the refrigerator. Defrost and clean it as written before. Leave the door open to avoid a build up of air inside.
Problem The appliance does not cool sufficiently

Possible cause The thickness of the frost is greater than 4-5 mm on the cooling plate. Thermostatic control is set too low. Too many foods to be cooled were put in. Very warm foods were put in. Door is not shut properly. There is no inside cool air circulation. The thermostatic control is set too high.

Solution Defrost the appliance. Set higher position. Put fewer foods to be cooled. Put foods max. at room temperature. Check if the door is shut. Provide inside cool air circulation. Set lower position.

The appliance cools too hard The appliance does not cool at all

Plug is not connected to the mains socket properly. Check if the connection is proper. There is no voltage in the mains socket. Thermostatic control is in �0� position. The appliance is not supported properly. Check if there is voltage. Check setting of thermostatic control. Check if the appliance stands stable.

The appliance is noisy

Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

46