|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
 ;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
 ;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
 ;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
 ;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
(6)
Remove three screws 9 which are holding the guide R (2nd) assy 0 to the bottom plate A. Remove the screw B which is keeping the rear cover C and guide R (2nd) assy 0. Remove the guide R (2nd) assy 0. (7) Remove the protect (M) D, guide bracket E, planet gears F and planet gear bracket G. (8) Remove the E-ring H which is keeping the sheet link I on the guide R (2nd) assy 0, and pull out the hinge stand J. (9) Remove three remaining screws K which are keeping the motor on the motor bracket L, and remove the connector off the Stepping Motor M. (10) Remove two screws N on the Stepping Motor M.
Detail A
0
I
C
J
K K L C B C
Q
O
H P
N
Note : The guide bracket E must be attached as shown in the following illustration:
No jutting of the gear shaft G is allowed into the oval hole E. Turn E clockwise for screw looseness to affix firmly.
M E F G
E
A 9
The upper plate 3 must be attached as shown in the following illustration.
3
9 0
185
|
|
 |
> |
|