|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
 ;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
;
Welcome. The scheme is clearly helped me to repair. Worth to download it.
HP LJ II-P Emulation Mode 17 � 7
Top Margin Setting
ESC&l#E 027 038 108 # 08 069 (101) 1B 26 6C # 45 (65) # = Number of lines
This command sets the number of lines in the top margin between the logical page and the text. Use this command to specify a top margin in line skips other than the defaultof one inch. To begin printing the 8th line for example the command would be: ESC&l8E ESC&a0R The second command moves the cursor to the newly defined top margin.
TEXT Length Setting
ESC&l#F 027 038 108 # 070 (102) 1B 26 6C # 46 (66) # = Number of lines
This command designates the number of lines in the current line feed pitch. If you wanted to print 55 lines on the page, the command would be ESC&l55F
Left Margin Setting
ESC&#L 027 038 097 # 076 (108) 1B 26 61 # 4C (6C) # = Column number Default = 0
This command sets the left margin in the column at the current (HMI) to the left edge of the text area. To set the left margin column to 10 substitute 10 for the # in the left -hand margin command above:
Right Margin Setting
ESC&a#M 027 038 097 # 077 (109) 1B 26 61 # 40 (60) # = Column number
This command sets the right margin in the column number at the current HMI to the right edge of the text area. The same can be done for the right margin. Remember the right margin cannot be less than the left margin. The combination command which sets both left and right margins at the same time is: ESC&a10l65M
|
|
|
> |
|
