|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
2. The ordinary DOS prompt �A:\>� appears. Input �G:[Enter]�. Then remove the FDD and insert the battery 2 instead of the FDD. 3. The prompt �G:\>PRG� appears and the active drive is changed. Input �CD \FD� to change directory. 4. When the prompt �G:\FD>� appears, input the command �BATT2�. 5. The battery 2 test starts. Execute the battery 2 test by following the instructions that are displayed. 6. Remove the battery 2 from the bay and insert the FDD that is removed in step 2. 7. When the test is complete, the prompt returns to �G:\FD>�. Input �A:� to change the drive. 8. Input �AUTOEXEC� to return to the main menu. (3) Fan test This tests the fan. 5. CD ROM test Tests the CD-ROM. 6. FDD test Tests the FDD. Note that the diagnostics floppy disk can be damaged when this test ends in fail. 7. HDD test Tests the HDD. 8. Touch pad test Tests the touch pad. Start pressing the keyboard surely from an end of a keyboard. The Fn key is disabled. Press �Fn+End� instead. 9. LED test Check that the LEDs start illuminating from the left of the LEDs. 10. Main memory test Tests the memory. 11. Main system test Tests the entire system including CPU, MATH and DMA. 12. Mouse test Tests the mouse. Move the cursor inside the white square mark ( instruction displayed. 13. Parallel loopback test Tests the parallel (printer) port. The jig is necessary. Connect the jig to the parallel port. 14. PC Card test Tests the PC card. The PC card tester jig is necessary. Insert and remove the PC card tester in accordance with instruction displayed.
PCG-F290 (UC) 2-6
) and operate the system in accordance with
 $4.99 PCG-F290 SONY
User Guide It's a complete guide ( also known as operating manual or owner's manual), and it's in PDF format. A…
|
|
|
> |
|
