|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
i.LINK S400 4 pin
MONITOR
Rear Rear Panel
AGP
USB
VGA CARD
DVI
CNX-211 BOARD
(Front Connector) KEYBOARD
MOUSE
CPU
PANEL2 PANEL1 CHASSIS FAN SOCKET 478 Harness (1394) MONITOR
MOTHER BOARD (MO) P4SD-VX
PRINTER Harness (USB2, SC)
MOTHER BOARD (MO) P4SD-VX
HEATSINK WITH FAN
i. LINK S400 6 pin
CNR
CNR Connector 1 6 USB X2 XMM Socket (�4)
ACT NETWORK LINK
CNR MODEM CARD (FCC)
LINE PHONE J2 J1
CNR
XMM1
XMM1 XMM2 XMM3 XMM4 1
MEMORY BOARD
HEAD PHONES LINE IN MIC
XMM2 XMM3
40 40
1 Harness (LED) GE PANEL 1 2 20 16 1
MEMORY BOARD
MEMORY BOARD AC INPUT 120V 4.5A 50/60Hz
XMM4
1
MEMORY BOARD P2
1
34
POWER SUPPLY
3 1 HD/CD LED POWER LED 19 STANDBY POWER SW Harness (IDE CD/DVD) 20 CMOS CLR 1-2: CMOS CLR 2-3: NORMAL
P1 P3 AUDIO (Upper side) 5inch Bay1 P5
OPTICAL DRIVE
IDE POWER 5inch Bay2
OPTICAL DRIVE
IDE P4 POWER (Lower side)
Harness (FDD) FDD IF
FDD
POWER
P8
From board to connector (direct connection) Harness (with connectors on both ends)
Harness (IDE/ATA66)
IDE
HDD
(Rear side) HDD Bay1 P6 POWER
Harness (soldering on either end)
The Mother board of service parts can be used without changing factory jumper setting, when it was replaced for service.
0CAUTION
Do not change the jumper with the power turned on. Before changing the jumper, turn off the power and disconnect the power cord from the set.
EXTENSION HDD
IDE
HDD Bay2 POWER
P7 (Front side)
Confidential
3-3 PCV-RS Series (AM)
|
|
|
> |
|
