|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
 ;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
;
When I purchased this manual I had my doubts regarding the quality as the price was so reasonable as compared to other outlets.
The manual itself is of high standard the print is very clear as are the diagrams. Obviously with the diagrams one has to zoom in otherwise it is to small to be able to read.
Overall I am very pleased with the company who delivered as they said and with the manual they supplied.
I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
I was at first dubious about payiong for downloaded manuals but having done so, I was extremely impressed with quality of the two manual I ordered, well worth the small price I paid.
I would highly recommend these to my friends.
;
reasonable price for the schematic - the service is perfect, all as expected and pointed by instructions - good scan of the original plans - thank you!
SECTION 2 FRAME HARNESS
� FRAME HARNESS DIAGRAM AND JUMPER SETTING OF MOTHER BOARD
i.LINK S400 4 pin USB
Rear Rear Panel
CNX-184 BOARD
(Front Connector)
U2
CN1
CPU
SOCKET 478 KEYBOARD
MOUSE
MOTHER BOARD (WA) P4S533-VL
U1
PANEL1 Harness (1394)
MONITOR PRINTER
4 1 8 1
MOTHER BOARD (WA) P4S533-VL
HEATSINK WITH FAN
i. LINK S400 6 pin
ACT NETWORK LINK USB X2 DDR Socket (�2) DDR1 DDR2 16 1 1 1 20 1 1 40 40 34 P2 1 3 P1 CMOS CLR 1-2: CMOS CLR 2-3: RTC CLR AC INPUT 100V � 240V 4.7A 50/60Hz
Harness (USB2, SC)
DDR1
MEMORY BOARD
HEAD PHONES
LINE IN MIC
DDR2
MEMORY BOARD
CNR Connector
CNR
MODEM CARD (CNR)
LINE PHONE J2 J1
CNR
POWER SUPPLY
Harness (MS, SIO)
MEMORY STICK CONNECTOR U1
P3
MS-CON2
CNX-180 BOARD
Harness (FDD) FDD IF AUDIO Power Switch POWER LED DVD-ROM/ CD-RW LED HDD LED IDE
FDD
POWER
P8
(Upper side) 5inch Bay1 P5 POWER 5inch Bay2
OPTICAL DRIVE
From board to connector (direct connection) Harness (with connectors on both ends) Harness (soldering on either end)
Harness (SW/LED)
CN1
Harness (IDE CD/DVD)
OPTICAL DRIVE
IDE P4 POWER (Lower side) (Rear side) HDD Bay1 P6 POWER
The Mother board of service parts can be used without changing factory jumper setting, when it was replaced for service.
SWX-120 BOARD
Harness (IDE/ATA66) IDE
HDD
0CAUTION
Do not change the jumper with the power turned on. Before changing the jumper, turn off the power and disconnect the power cord from the set. 2-1
EXTENSION
IDE
HDD Bay2 POWER
P7 (Front side)
HDD
Confidential
2-2 PCV-RZ_M Series (AM)
|
|
|
> |
|
