|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Attaching the unit stand
The unit stand allows you to place your Access Point in an upright position. When the unit stand is attached, wire cables are routed through the recessed groove.
Before attaching the unit stand
Make sure to write down the six-digit Access Point ID on the label attached on the bottom surface of the Access Point. Access Point ID
Note
Category 5 Ethernet cable is recommended or you may not be able to attach the unit stand to the Access Point.
Attach the unit stand to the Access Point as shown in the figure below. Engage Joint A with Joint B and slide the Access Point in the direction indicated by the arrow until it clicks.
Joint A
Joint B
Groove z Tip
The unit stand may be attached in either direction.
To remove the unit stand
Slide the Access Point and unit stand in opposite directions to detach.
18
|
|
|
> |
|
