|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm very happy that you all are performing an incredible good job. Furthermore what you did is very useful for all people as me that have electronics as an hobby.Thank you!!!!!
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
â� DISASSEMBLY PROCEDURE
1. Removing the COMMON PWB (1) Detach the 3 connectors. (2) Remove the 8 screws [A]. (3) Remove the COMMON PWB. 2. Removing the DIGITAL PWB (1) Detach the 4 connectors. (2) Remove the 6 screws [B]. (3) Remove the DIGITAL PWB. 3. Removing the HIGH VOLTAGE PWB (1) Detach the 3 connectors. (2) Remove the 22 screws [C]. (3) Remove the HIGH VOLTAGE PWB. 4. Removing the SIGNAL RELAY PWB (left) Note : Removing the heat-sink in advance is required. Refer to the following page to remove the heat-sink. C SCAN RELAY PWB COMMON PWB A COMMON BRANCH PWB F (1) Detach the 8 connectors. (2) Remove the 5 screws [D]. (3) Remove the SIGNAL RELAY PWB (left). 5. Removing the SIGNAL RELAY PWB (right) (1) Detach the 8 connectors. (2) Remove the 4 screws [E]. (3) Remove the SIGNAL RELAY PWB (right). 6. Removing the SCAN RELAY PWB (1) Detach the 5 connectors. (2) Remove the 10 screws [F]. (3) Remove the SCAN RELAY PWB.
B
HIGH VOLTAGE PWB
DIGITAL PWB E D
Heat-sink
: connector
SIGNAL RELAY PWB (left)
SIGNAL RELAY PWB (right)
G
Note : Check the state of the detached cables and connectors.
(1) Check any dirt or peeling in the contact part of the flat cable, and any crack, crease, disconnection and short-circuit of wires. (2) Check any foreign substance in the connector's contact . (3) Check the state of plugging the flat cable into the connector, and confirm it locks completely.
6(No.52091D)
|
|
|
> |
|
