|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
PDA-5001
8. PANEL FACILITIES AND SPECIFICATIONS
PANEL FACILITIES
1
2
3
�
+
AUDIO OUTPUT IN OUT IN OUT COMBINATION CONTROL RS-232C
(INPUT 4)
R SPEAKER 8 � � 16 �
R
(INPUT 3)
�
L
AUDIO INPUT
ANALOG RGB INPUT4
OUTPUT (ANALOG( RGB
4
5
6
7
8
9
0
-
1 AUDIO INPUT (Pin jacks)
Use to obtain sound when INPUT2 (BNC/S) is selected. Connect the audio output jack of components connected to INPUT2 (BNC/S) to these jacks.
7 CONTROL IN/OUT
For connection of PIONEER components that bear the � mark. Making CONTROL connection enables control of this unit as a component in a system.
2 AUDIO INPUT (Pin jacks)
Use to obtain sound when INPUT1 (BNC) is selected. Connect the audio output jack of components connected to INPUT1 (BNC) to these jacks.
8 RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS TERMINAL. This terminal is used in the factory setup.
3 INPUT1 (BNC)
For connection of components that have a composite video output jack. Use the INPUT1 OUT jack to output the video signal to an external monitor or other component. Note: The video signal will not be output from the INPUT1 OUT jack when the main power of the plasma display is off or in standby mode .
9 AUDIO INPUT (Stereo mini jack)
Use to obtain sound when INPUT4 is selected. Connect the audio output jack of components connected to INPUT4 to this jack.
0 AUDIO INPUT (Pin jacks)
Use to obtain sound when INPUT3 is selected. Connect the audio output jack of components connected to INPUT3 to these jacks. Note: The left audio channel (L) jack is not compatible with monaural input sources.
4 SPEAKER (R) terminal
For connection of an external right speaker. Connect a speaker whose impedance is 8 -16 �.
- INPUT4
For connection of a personal computer (PC) or similar component. Make sure that the connection made corresponds to the format of the signal output from the connected component. Use the INPUT4 OUTPUT terminal to output the video signal to an external monitor or other component. Note: The video signal will not be output from the INPUT4 OUTPUT terminal when the main power of the plasma display is off or in standby mode .
5 AUDIO OUTPUT (Stereo mini jack)
Use to output the audio of the selected source component connected to this unit.
6 COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE TERMINALS. These terminals are used in the factory setup.
26
|
|
|
> |
|
