|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Before
Spots
You Call
and Flatware:
Check
the following
if...
and Film on Glasses
Spotting can be caused by all of these things, Extremely hard water. � Low inlet water temperature. � Improper loading. � Old or damp detergent. � Too little detergent. Due to the varying local water conditions gives the best results for you. and personal preferences,
� Overloading the dishwasher. � Rinse aid dispenser empty. try different brands of detergent to find one that
To remove the spots and film from glassware1. Remove all metal utensils from the dishwasher. 2. DO NOT ADD DETERGENC 3, Select the NORMAL WASH cycle. 4. Start the dishwasher and allow to run for approximately 20 minutes. The dishwasher will now be in the main wash. &Then open the door and pour 1/2 cup (125ml) of white vinegar into the bottom of the dishwasher. 6. Close the door and allow the dishwasher home water softener. Glassware is Cloudy: remove the cloudiness, it is"etching." The film is permanent. to complete the cycle. Try using a vinegar rinse twice a month. Consider a
If vinegar doesn't To Prevent:
1. Use less detergent if you have soft water. 2. Avoid manually pre-rinsing the dishes. 3. The temperature Dishwasher � � � � of water entering the dishwasher should be 120 ° F - 140 ° F. Won't Drain: inlet.
If booked up to a food waste disposer, be sure the knock-out is removed from the disposer Be sure the drain hose is elevated at least 32" so water cannot siphon back into the tub. Check for food obstruction in the drain or disposer. Check drain hose for a kink. or fuse box.
� Check your home's circuit breaker � Check that the cycle is completed. There are Suds in the Tub: Sudsing detergents are not meant AVOID SUDSING. To remove suds from the tub:
for dishwashers.
USE ONLY AUTOMATIC
DISHWASHER
DETERGENTS
TO
1. Open the dishwasher door and sprinkle 1 cup of salt on top of the suds to help collapse them. 2. Close and latch the dishwasher. &Turn the dial until a drain is reached 4. Repeat if necessary. Dishwasher Leaks: is level. (Refer to the Installation Instructions.) designed for or select the drain pad.
� Check that the dishwasher
� Suds can cause the dishwasher to overflow. Measure the detergent carefully and use only detergents use in a dishwashen Less detergent is needed in soft water. Try another brand if sudsing continues. � To avoid rinse aid leaking Dishwasher � Dishwashers has an Odor: will have a "new" smell when installed. This will decrease with time. from the dispenser, be sure the lid is securely attached.
Wipe up any accidental
spills.
� Soiled dishes held too long. Use the Rinse & Hold, if available. � Dishwasher not draining properly. � A chemical odor is usually due to chlorine bleach in dishwashing
,i ,, ill
detergents.
You may want to try another brand.
* 8rand namesare trademarks the respective of manufacturer. For fllrther help, call Maytag Customer Assistance: U,S. 1-800-688-9900 or Canada 1-800-688-2002
MAYTAG � 403 West Fourth Street North
FormNo.225CMA PartNo.6-914376 , , _
� Newton, Iowa 50208 LitheU.$.]
http;//www,maytag,com
|
|
|
> |
|
