|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Delivery came quite promptly and in a very readable format. Thank you.
;
I found my Clarion VRX8370R in the Camper I bought and I wasn't able for month to understand it.
The Owner Manual was perfect and just what I was searching for.
Thank you.
Leonardo
;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
;
Zeer duidelijke afdrukken op A4-formaat , zeer uitgebreide handleiding . Pluspunt ,zeer snelle
respons van jullie , binnen de 24h . Top !!!
;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
Installation Procedure
7
Fine adjustment of the vertical tilt of the plasma display.
If the plasma display is slightly tilted from the vertical after it is installed on the wall, you can adjust this tilt by attaching the tilt adjustment metal fitting. Insert the tilt adjustment metal fitting in the notch on the top surface of the PDP side metal fitting that is tilted downward and attach it by rotating the screw. 1 Rotate the screw until the gap between the wall side metal fitting and the tilt adjustment metal fitting disappears. When the gap between the wall side metal fitting and the tilt adjustment metal fitting has disappeared, the screw becomes difficult to rotate and begins to lift up the plasma display. 2 Rotate the screw to adjust the tilt.
Tilt adjustment metal fitting
8
Locking the lock bar and fixing the lock plate firmly in place with push rivet and the anchor screw (M6 x 14mm) removed in step 1 (2 locations: left and right sides).
If you cannot fix the push rivet in place from the side, fix it in place from the bottom with the anchor screw (M6 x 14mm) (2 locations: left and right sides).
Plasma display
Screw head
Unlocked Locked position position
Gap
Lock the lock bar. Anchor screw (*2) Anchor screw (*1)
Tilt adjustment metal fitting
*1 If there are speakers installed on both sides, fix it in place with the anchor screw (M6 x 14mm) removed in step 1. *2 If there is a speaker installed on the bottom, fix it in place with the anchor screw (M6 x14mm) removed in step 1.
Note
The range that the tilt can be adjusted by the screw is about 5 mm of the external dimension of the plasma display and the screw rotates about 3 times. Be careful not to rotate the screw too much. If the screw is turned too much, the metal fitting may be damaged.
11
En
|
|
|
> |
|
