|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality scan of the document. I am very pleased with what I got.
;
PDF Contains
Technical Data, Mechanical data, Detailed Circuit diagram with components value, PCB layout. Actual PCBs Print. Component List, Spare parts code list and Input output detail. It cover LBB1211, LBB1212, LBB1213, LBB1216, LBB1217.
It is the actual Service Manual for SQ10
;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
5
6
7
8
3 X CONNECTOR A Assy, B Assy, 43 SCAN A Assy and B Assy
X CONNECTOR A and B Assy
Remove the one screw. Note: Be sure to remove this screw. If you don't, the connector on the LED OPT Assy may be damaged.
A
1 2 3 4
Remove the one nylon rivet.
6
6
43 X DRIVE Assy
6
Remove the LED OPT Assy.
6 5
Front chassis VR (43M) Flat clamp
6
Bottom view
Remove the enclosure sheet 1. Note: Enclosure sheet 1 is attached to comply with the safety standards. Make sure that it will not be shifted or peeled off. If it is peeled off, securely reattach it in its original place.
1
2
B
5 6
Remove the jumper wire by removing the flat clamp. Remove the front chassis VR (43M) by removing the five screws.
4
Enclosure sheet 1
3
LED OPT Assy
7 8
Remove the six screws. Remove the X CONNECTOR A and B Assy.
43 X DRIVE Assy
7
�2
7
�4
C
Note when reassembling the front chassis VR (43M) Remove or loosen the screws that secure the panel holder in order not to damage the front protect panel Assy.
8
X CONNECTOR B Assy
8
X CONNECTOR A Assy
43 SCAN A and B Assy
1 2 3 4
Remove the one nylon rivet. Remove the jumper wire by removing the flat clamp. Remove the one screw. Remove the front chassis VL (43M) by removing the five screws.
4
4
43 Y DRIVE Assy
4
D
4
Front chassis VL (43M)
Flat clamp
4 2
3
1
E
5 6 7 8 9
Remove the four screws. Disconnect the two pin connectors. Remove the two spacers. Remove the four spacers. Remove the 43 SCAN A and B Assy. 43 Y DRIVE Assy
5 6 8 9
�2
5 8 8 7
�2
6 7 8 9
43 SCAN A Assy
F
Note when reassembling the front chassis VL (43M) Remove or loosen the screws that secure the panel holder in order not to damage the front protect panel Assy.
43 SCAN B Assy
PDP-434CMX
5 6 7 8
113
|
|
|
> |
|
