|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
1
2
3
4
8.6 PRECAUTION ON REPLACEMENT OF THE POWER SUPPLY UNIT
A
Attachment of the housing wire
The housing wire (J126) is attached to the P11 terminal of the POWER SUPPLY unit. As the housing wire is not provided with the POWER SUPPLY unit for service, when replacing the POWER SUPPLY unit, remove the housing wire (J126) from the old one and attach it to the new one. NEVER turn on the unit before replacement, as doing so may damage the PC boards or the product. Note: The wiring shown in the photo is different from the actual power supply unit, because the product in the photo is a prototype.
B
POWER SUPPLY unit
C
D
1
Disconnect the housing wire (J126) from the P11 terminal on the old POWER SUPPLY Unit.
2
Connect the housing wire (J126) to the P11 terminal on the new POWER SUPPLY Unit.
Housing wire (J126)
Housing wire (J126)
E
1
P11
2
P11
F
POWER SUPPLY unit (old)
POWER SUPPLY unit (new)
144
1 2
PDP-5010FD
3 4
|
|
|
> |
|
