|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
At $5,00 certainly good bang for your buck. Includes electric schematics as well as exploded parts view + parts list for reordering. Unfortunately no details on the PCB contents or working, but then again, this is not overly complex. Best bonus: this manual does contain the heavily searched for LED error codes as well as descriptions for test operation. Haven't gotten around to fixing the machine yet, one thing the manual won't do for you is getting it out of the kitchen assembly :-(
;
It`s not your fault tear down is rather incomplete. It doesn`t have complete instructions as to deconstruction for repair.
 ;
THANK YOU FOR A GOOD TRANSACTION, NICE COPY, CLEAR
;
Very Good! All the diagram are easy to read, and its complete.
;
This was an excellent source of detailed assembly information on a device which is at least 12 years old. A very lucky find, coupled with great service.
5
6
7
8
7.1.5 CANCELING DETECTION BY THE TRAP SWITCH � Canceling detection by the TRAP switch
Outline: For video data transmission from the Media Receiver to the plasma display, digital signals are used. Therefore, this unit adopts the HDCP (High-bandwidth Digital Content Protection) system for copyright protection. This unit is also provided with a detection switch (TRAP switch) that will prohibit the unit from being turned on again if the rear case of the unit is opened, in order to prevent the panel technology from being leaked out. Function: To deactivate the detection of the TRAP switch Purposes: 1. During production of this unit, adjusting with the rear cover opened is possible. 2. During servicing or repairing, diagnoses of the assemblies are possible while the power is on. Methods: For setting, use RS232C commands: TSN: Ignore the monitoring of the switch CTM: Clear the detection log of the switch TSY: Reactivate monitoring of the switch Notes:
� � � � � The TRAP switch is located on the chassis (see Fig. below). Once rear case opening is detected, send the TSN and CTM commands. Because the TSN command is not stored in memory, monitoring of the switch can be reactivated by turning the unit off then back on. The same setting is possible using the Factory menu. Because the output of the DVI receiver is controlled by the physical setting of the TRAP switch, if the TRAP switch is set to OPEN, the DVI signal cannot be output even if the TSN command is sent. � When the Media Receiver is connected, detection by the TRAP switch can be canceled by entering Factory mode.
A
B
¶ How to enter Factory mode using the remote control unit Please refer to the technical documentation (Service knowhow). ¶ How to clear the detection log of the TRAP switch In the INITIALIZE layer, hold the OSD key on the remote control unit pressed for at least 3 seconds. ¶ After a power-down, to cancel detection of the TRAP switch using only the remote control unit, follow the procedures below. First, fix the TRAP switch to its depressed position. Set the drive ON/OFF switch in the DIGITAL VIDEO Assy to OFF, Then enter the Factory mode. Press the MUTE key four times, then hold the OSD key pressed for at least 3 seconds. Set the AC switch on the panel to OFF. The log is also cleared. Then set the drive ON/OFF switch to ON.
C
D
Rear View
E
TRAP switch
F
Fig. TRAP switch
PDP-504PU
5 6 7 8
63
|
|
|
> |
|
