PIONEER PDP-507XG/DLFR
Owner's Manual

02

Safety precautions

Installation precautions
Observe the following precautions when installing with any items such as the optional stand.

Side view
Mounting surface

Mounting bracket (or equivalent) Plasma display

When using the optional stand, brackets, or equivalent items
Ask your dealer to perform the installation. Be sure to use the supplied bolts. For details, see the instruction manual that comes with the optional stand (or equivalent items).

M8 screw 12 mm to 18 mm

When using other items
Consult your dealer. The following six mounting holes can be used for the installation:
Rear (PDP-507XG)

Caution � Be sure to use four or more mounting holes symmetrical to the vertical and horizontal median lines. � Use M8 screws, which go 12 mm to 18 mm in depth from the mounting surface of the plasma display. See the side view above. � Be careful not to block the ventilation opening at the rear of the plasma display. � Be sure to install the plasma display on a flat surface because it contains glass. � The screw holes other than the above are to be used only for the specified products. Never use them for mounting nonspecified products. Note � It is strongly recommended to use the optional Pioneer mounting products.

Mounting holes

Mounting holes

Median line

Median line

Rear (PDP-427XG)

Mounting holes

Mounting holes

Median line

� Pioneer shall not be liable for any personal injury or product damage that results from the use of mounting items other than the optional Pioneer products.

Median line

10
En