|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
1
2
3
4
No sound from the speakers (2/2)
A
A
No sound from the sub-woofer No
Is it sound for every function that doesn't come out? No
Is sound muting set? No
Yes
Cancel muting then check again.
Is a signal output from IC8002?
B
Yes
B
Check around IC8002 and No check the communications between IC8002 and the microcomputer.
Is the volume set to 0? No Are the headphones connected? No Is a signal output from IC8003? (3), (13)
Yes
Raise the volume then check again.
Yes
Has the signal arrived at TP8668 and TP8667?
No Check around IC8003 and check the buffer circuits.
Disconnect the headphones then check again.
45 46
Yes Has the signal arrived at TP9301 and TP9303?
B
Check the flexible cables No between the AV BOARD Assy and MR MAIN BOARD Assy
No Check around IC8003 and
34 35
Yes
B
No
check each input signal.
47 48
Yes Has the symptom been settled when the system cable is replaced? Yes
B
No
and between the MR MAIN BOARD Assy and MDR Assy.
Is a signal output from IC8008? (7), (10) Yes
36 37
B
No
Check around IC8008.
C
The panel is defective.
Is a signal output from IC8007? (1), (7)
Check around IC8007.
38 39
Yes
B
No
Finishing troubleshooting
Has the signal arrived at TP7710?
Check around Q7761.
49
Yes
B
Check around the jack.
D
E
F
134
1 2
PDP-R04E
3 4
|
|
|
> |
|
