|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
English 2. Fit the speaker to the brackets in the correct direction.
� Be sure not to mount the speaker upside down.
������������������� ������������������������������������������������� ���������������������������������������������������� ������������ ���������������������������������������� ������������������������� �������������������������� ������������������������
����������������� �������������������� ����������������� ���������������
Caution
������������������������������������� �����������������������������������
� To avoid any damage to the speaker and/or table top stand from striking against each other, �t the speaker to the bracket while con�rming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker was wrapped between the speaker and stand. � When the speaker brackets do not �t the grooves at the rear of the speaker, adjust the speaker brackets angle.
3. Tighten from back using the supplied screws (three locations).
� Tighten the three screws in order �, �, � as shown in the diagram.
CAUTION
�
Do not move the flat screen TV holding on to the bracket. This can result in injury or damage to the flat screen TV. The screw hole at the bottom surface of the speaker bracket is used when the �at screen TV is installed on the wall. It is not used when installed with the stand. NOTE: ����������������� ������������������ If after attaching the speaker its position needs to be adjusted horizontally or vertically, first
�
�
loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position.
4
|
|
|
> |
|
