OTHERS
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work. Condition Possible Cause Measure
Reference Page(s)
The power of the Dis- � The power plug play cannot be turned into the outlet. on.
is not inserted � Insert the power plug into the outlet.
27
The power is shut off � The temperature inside the Dis- � Remove obstacles covering the automatically play has become too high (bevents. cause vents have been covered). � Clean vents on the side and the rear. No image appears � You have switched to a wrong inon the screen. put. � You have not correctly connected the other necessary equipment to the Display. � You have not correctly adjusted the picture/picture quality. � The input signals are not acceptable for the unit. � The G on SYNC mode switch is set to ON although the G on SYNC signal is not input to RGB-2. The remote control � The batteries are dead. does not work. � There is some obstacle between the remote control and the remote control sensor. � The remote control is outside its controllable range. � Due to the infrared rays discharged from the screen. � Switch to the correct input. � Connect the other necessary equipment properly to the Display. � Adjust correctly the picture/picture quality. � Input signals which your Plasma Display can receive. � Set the G on SYNC mode switch to OFF.
28 28
12 20 to 26
14 to 16
20
� Replace the batteries. � Remove the obstacle between the remote control and the remote control sensor. � Operate the remote control within the controllable range. � Do not place obstacles which may reflect the infrared rays near the Plasma Display.
10 11
11 11
The picture is too � You have not correctly adjusted � Adjust the brightness and condark. * the picture/picture quality. trast of the picture correctly.
14 to 16
* CAUTION To prevent its panels and circuits, overheating when the surrounding temperature exceeds 40°C, this unit raises the rotational speed of the fan automatically to cool the insides. (The fan rotation sound will become louder.) The starting temperature of the above protection operation differs according to the images displayed, ventilation conditions of the external environment, whether dust has accumulated in the vents of the Plasma Display, etc. Use the Plasma Display in surrounding temperatures below 40°C. CAUTION To protect the panel drive circuit against unstable signal inputs, operations such as switching of inputs cannot be performed until the input becomes stable again. Consequently, if an equipment connected to the unit outputs unstable signals, it may not be possible to perform operations using the remote controller and buttons on the unit. This can be solved by disconnecting the equipment outputting the unstable signal.
30
<ARE1356> En
