|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent!! Got what I need and very fast!! Thank You
;
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
 ;
Service manual very complete and clear. It was very helpfull for my work.
;
This is the 2nd time I download manuals from this website and I can say it's what I was expecting. It contains schematic, layout (decent quality), short description, parts and dissasembly instructions. I recomend it for anyone who wants to repair/modify this device.
;
Very useful Service Manual! With it I was able to identify the damaged pots in my old amplifier, purchase the adequate replacements and make myself the repair.
I have again my old amplifier, still a very good one that I will keep for as many years as I can!
Thanks to Owner Manuals!
Speaker System: PDP-S02-LR
4.6.2 Mounting to the main unit
Two mounting methods are available. Proceed as follows. 1 Mounting to the sides of the display � The figure illustrates how to mount the speaker to the right side of the display.
[PDP-502] [PDP-501MX/PDP-V501X]
2 Mounting using commercially-available mounting components � This speaker system comes with M8 washers (ø25) for mounting the system using commercially-available mounting components. � Use either the center set of two mount openings or the lower set, which is designed for use with commercially-available mounting components. The two mount openings for either set are not level; the supplied washer provides the necessary compensation.
UP
UP
Cushion Mount components
UP
Secure at either pair of points, with the washer Flat screw Washer, M8 (ø25) Hole rivet Washer (ø15) Hexagonal screw fitted to the lower opening to level it with the upper opening.
Connection to a stereo amplifier
1. Switch off power to the stereo amp. 2. Use the supplied speaker cable to connect the speaker input to the amp output. The red input terminal (the terminal at the right in the illustration) is positive (+). The black terminal (at the left in the illustration) is negative (�).
1. Remove the lower two hole rivets from the rear of the display. (The hole rivet can be removed using a coin or other device.) 2. Mount the supplied mounting components to the speakers. (Take care to keep the protective cushioning from peeling off.) 3. Find the left and right speakers (check for �Left� and �Right� marks) and mount the speakers to the display, with the cushioning facing the display and the �UP� mark up, by first tightening the lower, then the upper mounting components. (At this point, the mounting components are only tightened temporarily.) 4. Securely tighten the flat screws to mount the mounting components firmly to the display, while positioning mounting components to ensure even clearance between the speaker and the display. � The use of screws other than those supplied may prevent secure installation or correct operation. Use only the supplied mount screws. � If you must move the display after the speakers have been mounted, grasp the lower part of the display instead of the speakers.
1 Pare the insulation from the ends of the cable and twist the bare wires.
2 Press the level and insert the ends of the twisted wires into the proper openings. Release the lever. Negative · terminal Positive ª terminal
To negative · terminal
To positive ª terminal
(Output from the stereo amp)
55
|
|
|
> |
|
