|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
 ;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
 ;
The downloaded quality was as good as the orignial
 ;
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
 ;
Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
PDP-501MX, PDP-V501X
2.Removing the Front Protection Panel (Fig. 3, Fig. 4)
1) Remove all screws 2 and 4 inside the front case. Be careful not to remove screws B (two at the bottom) and screws C (three at the top) because they are used for securing the aluminum sash. 2) Remove all panel shields 1 and 3 and panel holders 2 and 4. 3) Remove and replace the front protection panel. 4) Attach the protection panel by attaching to the bottom left side first, and then attach the front case assembly in the reverse procedure of the above. When securing the front case to the unit, attach the two bosses D (one each on the two edges of the top) as a guide so that the boss at the center A passes through the hole on the rear case. Note) When attaching the panel shield and panel holder after replacing the protection panel, the panel shield may deform when tightening the screws 3 as shown in Fig. 4. If it deforms, untighten screws 3 slightly and tighten until just before it starts to bend.
3 3 2
Panel cushion 50V Panel cushion 50V Panel cushion 50H
4
Front protection panel 2 Shield gusket F Shield gusket D
2 2 1 2 1 2 2
3 3
3 C D
C
Panel cushion 50H
1 A
2 1
2 2
Shield gusket F Shield gusket C Shield gusket E
Shield gusket D
2 2 1 1
2 2 2 2 2 2 2 1 1 2 B
Shield gusket G
C D 3
Shield gusket B
3
B
4
Shield gusket H
3 3 3
Front case
3 3
Aluminum sash D Aluminum sash U
Fig. 3
77
|
|
 |
> |
|