|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
 ;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
;
Très-très bon site, facile, très bon prix.
Au futur besoin, je n’hésiterais à faire appel à vous.
Merci
Procedure: 1. Install the SD card with calibration code into camera. 2. Attach camera to AC adapter. The camera starts to sound �di di� and then enter the Bright Level to adjust the menu. 3. Use the test pins of multimeter to touch the camera as shown. The black pin touches to the metal frame (GND), and the red pin touches to the LCD negative soldering pad (white wire). 4. Use touch pen on touch panel to adjust the reading on multimeter is 370 +/- 5mV, then press the shutter button to save it. 5. Repeat the above step 3 to adjust the reading to 220 +/- 5mV for Normal Level. 6. Repeat the above step 3 to adjust the reading to 100 +/- 5mV for Dim Level. 7. Press shutter button to get out of the calibration status.
The position on touch panel KEY
SAVE
*
=
Shutter Button Fig 3-7
3-3 LCD Calibration Test Tools: AC Adapter SD Card with Calibration Code [lcdcal.exe] --- Self-extracting execution Oscilloscope The all test points for vector pins are on the logic board U100. The setting of scope: Setting 1: CH1---VG(the white wire as shown), 0.5V, 25.0uS; Trigger Signal: CH4---VCOM; Synchronization: scanning Setting 2: CH1---VG(the white wire as shown), 0.5V, 25.0uS; CH2---VR(the black wire as shown), 0.5V, 25.0uS; Trigger Signal: CH4---VCOM; Synchronization: scanning Make sure the waveform of CH1 and CH2 is overlap together, then switch off the CH1 and CH2. Choose MATH, �-� to get the waveform of �CH1-CH2�. Setting 3: CH1---VG(the white wire as shown), 0.5V, 25.0uS; CH2---VB(the blue wire as shown), 0.5V, 25.0uS; Trigger Signal: CH4---VCOM; Synchronization: scanning Make sure the waveform of CH1 and CH2 is overlap together, then switch off the CH1 and CH2. Choose MATH, �-� to get the waveform of �CH1-CH2�. Setting 4: CH4---VCOM(the brown wire as shown), 1.0V, 25.0uS; Trigger Signal: CH4---VCOM; Synchronization: scanning GND: the red wire as shown
11
|
|
|
> |
|
