|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
 ;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
 ;
Service Manual that I received was very helpful to me. Thank you.
 ;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
 ;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
PDR-W739
6.5.4 Focus Bias Adjustment
Test Point Adjustment Point Adjustment Value Symptom when out of adjustment [Procedure]
(1) Press the SYNCHRO button in Stop mode. Note: Make sure the unit is in Stop mode. (2) Check that "OPT" disappears on the FL display. (3) Press the AUTO SPACE button so that "CDR 04ff34��" appears on the FL display. (4) Press the FINALIZE button for focus-in. (5) Press the PLAY/PAUSE 6 button for CAV-servo spindle kick. (6) Press the PLAY/PAUSE 6 button to close the tracking servo, then set the unit to Playback mode. (7) Adjust with the REC LEVEL knob until the above adjustment value to be reached is obtained. Press the REC LEVEL knob to register the adjustment. Once the adjustment is registered with the REC LEVEL knob, " ERASE " on the FL display will disappear. (8) Press the STOP button to stop the unit. CN102 - pin 1 (RF) SYNCHRO button, REC LEVEL knob Adjust until RF jitter is minimal or that the eye pattern of the RF waveform is most open. Sound broken, record characteristics deteriorate
RF 10 : 1 VC 10:1 probe Jitter Meter or Oscilloscope
Note: Adjustment must be done around mid-radius on a disc.
69
|
|
 |
> |
|