|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
THIS MANUAL IS VERY GOOD AND VERY CLEAR
PLEASE NOTE IT DOES NOT CONTAIN THE SETUP INFORMATION TO ALIGHN THE GEARS IN THE CD MECH IT DOES SHOW ALL THE PARTS AND THEIR LOCATIONS .
;
Complete service and operation manual. All schematics are there, all circuit boards AND add-on boards. Including exploded views ,component names and specifications. Also electrical and mechanical adjustment procedures are in this manual. This manual also covers the more advanced BR-S811E unit. Scan quality is fair and usable.
 ;
High quality scan of original Service Manual. Everything´s fine!
;
Good scan of the original service manual. All schematics and adjustment procedures are there. It helped me to fix a long lasting problem with the tracking circuitry. The manual also includes the supplementals 1,2 and 3. Included are; electrical schematic's , pcb layout's, mechanical drawing's and exploded views, disassembly manual and maintenance procedures. 236 pages.
;
The Service Manual received was helpful. The electronic information is exactly what I needed.
I recomend all of my friends about this technical page.
5
6
7
8
6.2 ADJUSTMENT REQUIRED WHEN THE SET IS REPAIRED OR REPLACED
INTERFACE Assy
When repaired
No adjustment required.
Y DRIVE Assy
When repaired
Note: If the Pulse Module fails, it is not possible to repair the Y DRIVE Assy by replacing only the Pulse Module. Replace the entire Y DRIVE Assy. � VOFS/VH/IC5V voltage adjustment
A
When replaced
No adjustment required.
When replaced
SW POWER SUPPLY Module
When replaced
No adjustment required.
� Panel white balance adjustment
X DRIVE Assy
When repaired
B
DIGITAL VIDEO Assy
When repaired
No adjustment required.
Note: If the Pulse Module fails, it is not possible to repair the X DRIVE Assy by replacing only the Pulse Module. Replace the entire X DRIVE Assy. � VRN voltage adjustment
When replaced
1. Remove IC1204 (24LC04(1) SN-TBB) from the former PC Board to replace, and install it to the new PC Board. 2. When use new Assy which replaces it and recovered as service parts once again, replace IC1204 with new IC.
When replaced
� Panel white balance adjustment
C
SW POWER SUPPLY Module
D
Y DRIVE Assy
X DRIVE Assy
E
DIGITAL VIDEO Assy
INTERFACE Assy
Fig. 1 PC Board Location (rear side view)
F
PDU-50WX2A
5 6 7 8
49
|
|
|
> |
|
