|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
 ;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
Troubleshooting
..............................................
My CLI� handheld does not work properly
I cannot turn on my CLI� handheld
B Is the POWER/HOLD switch of your CLI� handheld in HOLD mode? Your CLI� handheld does not work when the POWER/HOLD switch is in HOLD mode. Make sure you release HOLD mode.
Note If you press the application buttons, Data Assistant button, or CAPTURE button, or slide down the VOICE REC switch, or open the camera lens cover during HOLD mode, the POWER LED blinks 3 times. However, your CLI� handheld does not operate.
B Has the battery power of your CLI� handheld run out? Connect your CLI� handheld to the AC power adapter with the plug adapter, then allow it to be charged for a few minutes before turning it on. If it turns on, continue charging for approximately five hours and then perform a soft reset by pressing the RESET button of your CLI� handheld. b For details, refer to �Basic operations of your CLI�� handheld: Restarting your
CLI�� handheld� in the supplied �Read This First (Operating Instructions)�.
B Is the connector between your CLI� handheld and the plug adapter dirty? You cannot charge your CLI� handheld if the connector is dirty. Connect and disconnect your CLI� handheld and the plug adapter several times to clean the connector. B Perform a soft reset by pressing the RESET button of your CLI� handheld. b For details, refer to �Basic operations of your CLI�� handheld: Restarting your
CLI�� handheld� in the supplied �Read This First (Operating Instructions)�.
The screen is not displayed even though the POWER LED is on
B Is the POWER/HOLD switch of your CLI� handheld in HOLD mode? The screen is not displayed when the POWER/HOLD switch is in HOLD mode. Make sure you release HOLD mode.
12
|
|
|
> |
|
