|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It was very usefull, it is clear the quality is super, the price I paid is very afordable.
Generally speaking Iam very happy with this company.
 ;
The manual was exactly what I needed, Good quality scans too. superb.
 ;
I am so happy found this site as it consists of so many Manuls and easy to aquire. This onei s exactly what I wanted and much more as it has info on not only how to use the tuner but how to repair it as well. I will come here 1st before purchasing else where! Thanks owner-manual.com!
 ;
Top class product, I printed it out on A3 paper and it is clear and very easy to follow.
Cheaper than buying a new radio!
 ;
is part of the manual is very useful for repairing
Here are circuit diagrams
if there is damage, I recommend using this part of the
a complete list of circuit boards and components
1-5. Replacement of Board
4. Insert the main board along the board guides with the board lever closed in the direction of arrow 2 shown in the figure. Then, connect the main board securely to the connector on the MB-932 board.
MB-932 board Board guides Main board
1-5-3. PS-607 Board
w Be sure to pull out the power plug of the unit from the wall outlet before initiating the replacement operation. 1. Remove the front panel. (Refer to Section 1-1.) 2. Remove the top plate. (Refer to Section 1-1.) 3. Disconnect the three harnesses from the connectors (CN1, CN2, and CN3) on the PS-607 board. 4. Remove the five screws. 5. Remove the PS-607 board.
A side
PSW 3x6 Harness Harness CN1
2 Board lever
PSW 3x6 Harness
PSW 3x6 CN2
5. Set the switch (S1) on the PS-607 board to ON. 6. Install the front panel.
CN3
PS-607 board
1-5-2. Connector Board
1. Remove the two screws, then remove the connector panel.
B 2.6x4 Connector panel
6. Secure a new PS-607 board to the PFV-L02 with the five screws. 7. Connect the harnesses to the PS-607 board. 8. Confirm the supply voltage. (Refer to the next page.) 9. Install the top plate. 10. Install the front panel.
2. Secure a new connector panel to the PFV-L02 with the two screws.
1-4(E)
PFV-L02
|
|
 |
> |
|