|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast, clear and useful. Important for me: the manual is in German.
 ;
Very good quality. Some parts are not fully readable, but the fundamental ones are fine.
;
very good quality readable manual,printed off very well.
;
The manual was very accurate for the part that I was changing, I was able to order the correct part and had no issues with the replacement procedure. However, I was expecting to have more detailed repairs for the lower drive unit.
;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
PG-M10SU/SE PG-M10XU/XE 14)Lamp housing (See Fig. 15.) Remove the three screws (S-7) shown in Fig. 15, and detach the lamp housing from the bottom cover. Remove the screws (S-15) shown in Fig. 15, and detach the thermistor and thermistor plate. Remove the screw (S-7) shown in Fig. 15, and detach the ballast lock base. With the lamp housing taken out, the 40 fan assembly (DC) can be detached. Note: Take note of the wiring for the 40 fan assembly, which goes below the lamp housing.
40FAN(DC) S-7 Lamp housing S-15 Thermistor Ass�y S-7 Thermistor Plate S-15
Front Foot
16)Front and rear feet (See Fig. 17.) As shown in Fig. 17, press the hook (1) first and then the hook (2). Remove the front feet. Turn the rear feet away out of place. Remove the screw (S-7) shown in Fig. 17, and detach the lamp limit switch.
S-7 Lamp Limit Switch Rear Foot
Fig. 17
Fig. 15 15)Power unit (See Fig. 16.) Remove the two screws (S-7) shown in Fig. 16, and detach the fan base from the cover. Remove the screws (S-5 and S-10 one each) and the two D/M spacers shown in Fig. 16, and detach the power unit.
S-5 S-10 D/M Spacer
40FAN(L) S-7 Power Unit
S-7 Fan Base
Fig. 16
14
|
|
|
> |
|
