|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service manual includes everything is need to repair this radio-caseete, how to disassemble, wiring diagram, all , waiting time until the download was only a few hours. I'm going to buy service manuals from here, are cheap and very good.Thank you.
;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
PG-M17X
Lamp
The lamp in this projector operates for approximately 1,500 cumulative hours, depending on the usage environment. It is recommended that the lamp be replaced after 1,400 cumulative hours of use or when you notice a significant deterioration of the picture and color quality. The lamp usage time can be checked with the On-screen Display.
CAUTION Intense light hazard. Do not attempt to look into the apertur e and lens while the projector is operating.
As the usage environment can vary significantl y, the projector lamp may not operate for 1,500 hours. 1,500 hours above indicates average life span and should be used for r eference only. This is different than the warranty period. For safety, the power will not be turned on from the fourth time when turning on the power without changing the lamp after use for 1,500 hours.
Condition The LAMP REPLACEMENT indicator illuminates red, and LAMP will appear in yellow in the lower-left corner of the picture. A significant deterioration of the pictur e and color quality occurs. The power will automatically turn off and the projector will enter standby mode. LAMP will appear in r ed in the lower-left corner of the pictur e, and the power will turn off.
Problem Lamp has been used for over 1,400 hours.
Possible Solution Purchase a replacement lamp unit (lamp cage/module) of the curr ent type BQCPGM17X//1 from your nearest Sharp Authorized Projector Dealer or Service Center. Replace the lamp. If you wish, you may have the lamp replaced at your near est Sharp Authorized Projector Dealer or Service Center.
Lamp has been used for over 1,500 hours.
1
Turn off the power.
2
Disconnect the power cord.
3
Remove the lamp cage cover.
Press ON/OFF on the projector or POWER on the remote control. Wait until the cooling fan stops.
Unplug the power cord from the AC socket.
Turn over the projector and loosen the user service screws that secure the lamp cage cover. Then lift open the cover in the direction of the arrow.
or
4
Remove the lamp cage.
5
Insert the new lamp cage.
6
Attach the lamp cage cover.
Loosen the securing screws on the lamp cage. Hold the lamp cage by the handle and pull it towards you.
Press the lamp cage firmly into the lamp cage compartment. Fasten the securing screws.
Slide the lamp cage cover in the direction of the arrow. Then tighten the user service screws.
21
 $4.99 PGM17X SHARP
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
