SONY PMCMD55
Service Manual

Timer-recording radio programs
You can set timer to record the radio at a certain time. You can also record from the component connected to the LINE IN jack of the player. Make sure you have set the clock (see �Setting the clock� on page 46).

STANDBY Jog dial

TIMER

YES ENTER

Notes � You cannot preset recording timer and waking up timer (page 48) at the same time. � When recording from the component connected to the LINE IN jack of the player, refer to the operating instructions of the component.

Before you begin, make sure �TIMER PLAY� or �TIMER REC� is not displayed. If either one is displayed, press STANDBY.

1 2

Tune in the radio station and insert an MD. Press TIMER. �TIMER PLAY� or �TIMER REC� flashes in the display. Make the following settings by checking the indications in the display.

3 4

Turn the jog dial until �TIMER REC� flashes in the display, and press YES�ENTER. Turn the jog dial until �RADIO� flashes in the display, and press YES�ENTER. When recording from the component connected to the LINE IN jack of the player, turn the jog dial until �LINE� flashes in the display, and press YES�ENTER.

Tip If you made a mistake, press NO�CANCEL. The setting entered last will be cleared. Reenter it.

5

Set the timer to the hour and the minutes you want to start recording. 1 Turn the jog dial to set the hour and press YES�ENTER. 2 Turn the jog dial to set the minutes, and press YES�ENTER.

50

The Timer