6
REMOVE THE HARDWARE PARTS
3 5 1 7
[PARTS LIST]
No. PARTS NAME MICRO S/W UNIT PWB UNIT SCREW (M2 � 12) MOTOR (PR58H) SCREW (M3 � 6) SCREW (M3 � 5) HOUSING 58H
4 5 2
Q�ty 1 1 1 2 4 1 1
4 6
Fig. 16
[DISASSEMBLY METHOD] <MICRO SWITCH>
1) Remove the connector cable of the MICRO S/W UNIT the connector CON5 (2 pins) of the PWB UNIT 2) Remove the SCREW . . and the MICRO S/W UNIT from
[Cautions to be taken when reinstalling]
1. Wire the MICRO SWITCH UNIT Secure the MICRO S/W UNIT ing torque: 4.0 kgf-cm).
3
cable as shown below. with the SCREW (tighten-
Wire the MICRO SWITCH cable as shown in the figure.
<JOURNAL SIDE MOTOR>
1) Remove the connector cable of the MOTOR nector CON5 (6 pins) of the PWB UNIT . 2) Remove the two SCREWs and the MOTOR from the con.
<RECEIPT SIDE MOTOR>
1) Remove the connector cable of the MOTOR nector CON7 (6 pins) of the PWB UNIT . 2) Remove the two SCREWs and the MOTOR from the con.
Push the cables into the grooves.
Fig. 17 2. Wire each cable as shown below.
<PWB UNIT>
1) Remove the SCREW and the PWB UNIT .
Journal motor cable Twist the cable.
Earth cable Receipt motor cable Twist the cable.
CN6
CN7 CN3 CN5
CN2
Micro switch cable
Fig. 18
