|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
;
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
;
I am proud of you. In the future, I benefited from your services.
;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
5
6
7
8
INSTALLATION
A
1. Remove the PRV-LX1 top panel. � Remove the seven screws in the top panel and the top panel (these screws will be used to reinstall the top panel in Step 14).
Top panel
B
2. Remove the rear panel blind plate. � To prevent the blind plate from dropping, hold it in place while removing the two black installation screws (these screws will be used to reinstall the terminal cover in Step 12). Blind plate Remove the blind plate on the left (as seen from the rear) to install the PRA-BD11 input board. Note: Make sure that the removed screws are not mixed up with the screws supplied with this unit.
C
Remove the blind plate on the right (as seen from the rear) to install the PRA-BD12 output board.
3. Remove the rear bridge. � Remove the four installation screws and the rear bridge (these screws will be used to reinstall the bridge in Step 9). Rear bridge Note: Make sure that the removed screws are not mixed up with the screws supplied with this unit.
D
E
F
PRA-BD11
5 6 7 8
61
|
|
|
> |
|
