|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent manual. In addition to the information I needed was a complete description of both electronic and mechanical devices.
Excellent site.
Thank you very much.
 ;
very good and complete manual , it is in english and german is perfect for repair.
;
This manual is complete and of high quality. I am very pleased with the purchase.
;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
1
2
3
4
How to replace the fan in the ATX Power Supply unit
A
Removing the fan
1 Remove the switch-barrier fixing screw on the ATX Power Supply unit (DXF1001) then slide the switch barrier, as indicated in the figure. Note: Be sure to set the POWER switch to OFF and disconnect the AC power cord from the AC outlet before starting this step.
Switch-barrier fixing screw Switch barrier ATX Power Supply Unit (DXF1001)
B
2 Remove the fan guard, then remove the fan and disconnect the harness from the fan connector.
C
Fan Cleaning
Fan connector Remove the fan.
Cleaning paper : GED-008
Attaching the fan
1 Connect the harness to the fan connector and install the fan into the panel. Push the harness inside.
Notes: � Place the fan so that the name plate of the fan can be seen from the front. � Use the Fan Unit (DZM1001) dedicated to the ATX Power Supply unit (DXF1001).
Fan Cleaning Cleaning paper : GED-008
D
Push the harness inside so that it will not come out. Name plate can be seen.
Hook the slots.
2 Attach the fan guard.
Close.
E
3 Slide the switch barrier and tighten the screw.
1. Slide
F
2. Tighten the screw.
160
1 2
PRV-LX1
3 4
|
|
|
> |
|
