|
Who's Online
There currently are 5974 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very good reproduction (copy) of original manual. Didn't have a parts list, but schematic was completely labeled with parts. Complete instructions on how to adjust mechanical functions of the 8-track deck. Well worth having and at a very reasonable cost.
;
It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
;
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
;
It was complete service manual with all needed service informations. Thanks.
;
El manual esta muy detallado, los numeros de partes y los esquemas de despiece son correctísimos y muy claros, tanto para los técnicos experimentados como para los novatos.
1
2
3
4
How to replace the fan in the ATX Power Supply unit
A
Removing the fan
1 Remove the switch-barrier fixing screw on the ATX Power Supply unit (DXF1001) then slide the switch barrier, as indicated in the figure. Note: Be sure to set the POWER switch to OFF and disconnect the AC power cord from the AC outlet before starting this step.
Switch-barrier fixing screw Switch barrier ATX Power Supply Unit (DXF1001)
B
2 Remove the fan guard, then remove the fan and disconnect the harness from the fan connector.
C
Fan Cleaning
Fan connector Remove the fan.
Cleaning paper : GED-008
Attaching the fan
1 Connect the harness to the fan connector and install the fan into the panel. Push the harness inside.
Notes: � Place the fan so that the name plate of the fan can be seen from the front. � Use the Fan Unit (DZM1001) dedicated to the ATX Power Supply unit (DXF1001).
Fan Cleaning Cleaning paper : GED-008
D
Push the harness inside so that it will not come out. Name plate can be seen.
Hook the slots.
2 Attach the fan guard.
Close.
E
3 Slide the switch barrier and tighten the screw.
1. Slide
F
2. Tighten the screw.
160
1 2
PRV-LX1
3 4
|
|
|
> |
|