|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
PRO-200, PRO-100
14 -3 Tint adjustment
Start 1st FAC
"Color bar"
(DOWN)
ADJUSTMENT OFFSET
Adjust the screen to optimum condition.
TINT
2
DVD COMPONENT VIDEO INPUT
DVD Player
� For the adjustment of 14 -2 and 14 -3. When it does not have the color bar generator with component video output. (However, make it finish the adjustment of composite video in advance.) 1. Prepare the DVD player with the component video output and the Video software. 2. Input the component signal to the DVD COMPONENT VIDEO INPUT of the TV, and input the composite signal to the VIDEO 1 INPUT. 3. Set the AV MEMORY of LD/DVD, VIDEO 1 to the STANDARD in the normal use mode (It does not enter the FACTORY ADJ mode.) 4. Playback the Video software. 5. Adjust the value of COLOR and TINT of PICTURE of MENU1 with seeing sometimes video of VIDEO 1 so that the video (color) of LD/DVD becomes the same as the video of VIDEO 1. 6. The adjustment is complete, read the value of COLOR and TINT in the MENU, and change it into the value in FACTORY in accordance with the following table. Example: In MENU �30 �15 +15 +30 MENU FACTORY 2Steps 2Steps 2Steps COLOR +17 +19 In FACTORY COLOR TINT 2Steps TINT �5 �10 7. Input the changed value to COLOR and TINT of the component offset in the FACTORY ADJ mode. (End)
14 -4 Contrast adjustment
Start 1st FAC
(DOWN)
"Color bar"
Adjust the screen to optimum condition.
3
"Normal video signal"
ADJUSTMENT OFFSET
CONTR
At the TP-BK of the B. CRT DRIVE assy, check that the signal is shaped as shown below A .
A Shapely waveform
saturated B Shapeless waveform
original page 158
58
|
|
|
> |
|
