|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
05
Preparation
Attaching/detaching the PIONEER stand (for PRO-940HD only)
The PRO-940HD comes with the PIONEER table top stand attached. You can mount the display in a rack by detaching the stand. The method for attaching/detaching the stand varies depending on the particular panel.
NOTE
� Install the panel on a flat, stable location to avoid warping the glass components.
Reattaching the stand
1 Fit the stand�s support columns under the Plasma Display
shown below. Slowly ease the panel down on the supports. � Be extremely careful not to insert the stand supports into any part of the Plasma Display other than the stand insertion slots. If the panel is mounted improperly, the communication ports could be damaged or the stand could be warped.
CAUTION
� If mounting the panel on a stand, use only the attached stand for this model. Other stand models are not authorized for this panel. � Two or more people are required to assemble and install this unit.
Detaching the stand
1 Loosen the two installation bolts � using the enclosed
hexagonal wrench.
Line up the column supports with the bottom of the Plasma Display . Installation bolts � (M8 x 30 mm: silver)
2 Bolt the Plasma Display to the stand at the points
indicated by the arrows.
2 Remove the two installation bolts � using the same
hexagonal wrench.
Installation bolts � (M8 x 60 mm: silver) Installation bolts � (M8 x 60 mm: silver)
3 Tighten the installation bolts � firmly using the enclosed
hexagonal wrench.
3 Lift the Plasma Display from the stand.
Installation bolts � (M8 x 30 mm: silver)
NOTE
� Keep the installation bolts � and � for reattaching the stand to the Plasma Display at a later date. 22
En
� Install the panel on a flat, stable location to avoid warping the glass components. � Insert the screws in the holes vertically. � Do not tighten them with more force than necessary.
|
|
|
> |
|
