REMOTE CODE SET UP
To operate other manufacturers' audio/video units using the TV remote control unit, remote control signals need to be set. There are two methods of setting remote control signals � For calling the other manufacturers' remote control signals preset to this remote control unit � For learning other manufacturers' remote control signals
TV
POWER
TV/ CBL VCR DVD DTV /SAT /LD
ON/OFF
TV
DTV INPUT
1
SPLIT
2
SEARCH
3
SELECT
4
CALLING OTHER MANUFACTURERS' REMOTE CONTROL SIGNALS PRESET
SCREEN
MODE
SUB CH ANT
FREEZE
DTV
AUDIO
DISPLAY
1
1 4 7
2 5 8 0
¢
3 6 9
ENTER
Set the mode switch to match the device to which you want to preset the remote control signal.
� Example: To select DVD/LD.
TV/ CBL VCR DVD DTV /SAT /LD
CH
CH
RETURN
|\
VOL
CH
MUTING
4
2
DTV/DVD TOP
MENU
At the same time, press the EDIT button and number button 1.
LED will begin blinking.
EDIT/
LEARN
TV/SAT/DVD
MENU
SOURCE
POWER
DTV/SAT
5 2
SET/ ENTER
GUIDE
3
DTV/(SAT)
INFO
VCR REC
8
1
POWER
�
FAVORITE CH
EDIT/
LEARN
TV/ CBL VCR DVD
7
INPUT
3
VOL
¡
VOL
1
TV
POWER
DTV /SAT
ON/OFF
/LD
RECEIVER
TV
DTV INPUT
1
2
3
4
PROJECTION MONITOR RECEIVER REMOTE CONTROL UNIT
�
3
Select the desired manufacturer.
� � Select from the figure on page 69. Example: To select 24 (PHILIPS) in the LD mode.
2
NOTES: � To stop the EDIT mode in the middle, press the EDIT button once more. � If mode switch is switched while in EDIT mode, EDIT mode will be canceled. � After step 1 and step 2, if you do not press the button for one minute (no operation), the EDIT mode will be canceled. � If the table on page 69 does not include your desired manufacturer or the remote control does not work, you can make the memory learn its signal by the learn mode (see page 70). � The initial mode is �00� (PIONEER).
4
� �
If the LED blinks rapidly when the number button has been pressed, there has been an error. Input the number again. After setting, you can automatically use the remote control in the usual manner.
68
<ARB1527>
