|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast, clear and useful. Important for me: the manual is in German.
 ;
Very good quality. Some parts are not fully readable, but the fundamental ones are fine.
;
very good quality readable manual,printed off very well.
;
The manual was very accurate for the part that I was changing, I was able to order the correct part and had no issues with the replacement procedure. However, I was expecting to have more detailed repairs for the lower drive unit.
;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
PRO-700HD
10 -4
Red line adjustment
1st FAC
� Adjustment in the vertical direction
Start ¶ Vertical correction adjustment of the red line
� Select the Adjustment item
RV - STATIC
1
CH
� Adjust the Data value
2 5 8 0 3 6 9
VOL
or
4 7
or
In particular, be aware of the setting before adjustment.
Note : � Repeat the adjustments until you attain the optimum state. � Fine-adjust over the entire picture to obtain the optimum picture. � If the adjustment of V-STATIC is not possible within the range of 010 to �010, set the data value to 0, turn the centering magnet of the deflection yoke and fine-adjust V-STATIC. Adjustment Method
Adjustment Item 1 2 3 4 5 6 7 RV-STATIC RV-SKEW RV-BOW RV-3D SKEW RV-4D BOW (RV-5D SKEW) (RV-6D BOW)
� � � � � � � � � � � � �
Screen No.
1 2 5 3 6 4 7 8 q 9 w p e
� Adjust the red center to match the green center.
� Adjust so that the red horizontal line at the center overlaps with the green horizontal line.
Note: Do not adjust items 6 to 7.
1 2 3 Line-interval Center-line Adjustment 4 5 6
RV-SIZE RV-LIN RV-MID SIZE RV-MID LIN (RV-5D SKEW) (RV-6D LIN)
� Adjust the interval at the center of the red vertical line to the interval of the green vertical line.
Note: Do not adjust items 5 and 6.
7 Screen
� STATIC
1
Key No.
¶Screen�s changes in the vertical direction when manual convergence adjustment is mode The changes at the arrow parts shown below are those implemented using the Volume ª key. Changes are opposite to the arrow when the Volume · key is used.
`
� SKEW
2
� 3D SKEW
3
� 5D SKEW
4
Key No.
� SIZE
8
� MID SIZE
9
� 5D SIZE
10
Key No.
1
� BOW
8
5
� 4D BOW
6
� 6D BOW
7
Key No.
� LIN
11
� MID LIN
12
� 6D LIN
13
Key No.
2
= Fixed position
7
Fig. 7. Vertical correction (1)
198
|
|
|
> |
|
