|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This PDF is very comprehensive. It includes drawings, parts lists, schematics, pictures, PCB drawings, mechanical layouts, etc. for all three stackable equipment. The scans are good too. Easy to read and no smudges or black lines. I have no complaints. I will make this site my first stop for finding my service manuals.
 ;
This service manual includes drawings, schematics, exploded views, parts list, operating details, and more. Very good scans, very readable. The only thing that made it a 4 star rating was on approximately 4 scans only half of the page was scanned then the other half. I would have preferred the pages to be whole scans.
;
Good manual contains all it takes to update, repair,these types of mixers.Thanks.
;
Great service. Fast response. High quality scan. Good price.
Thank you very much!!!
Oleg S.
;
Well-scanned, complete manual. Contains the information needed for repair and maintenance.
1
2
3
4
Input Signal Step
A
Adjusting Method
Adjust the black level of the Red and Blue signals referring to that of the Green signal Adjust the signal amplitude of the Red and Blue signals referring to that of the Green signal
Green signal waveform
Green signal waveform
Red or Blue signal waveform
Signal amplitude of the Green signal
Red or Blue signal waveform
B
Black level of the Green signal
Video signal
Black level of the Red or Blue signal
14
C
15
Increase the MAT CONT adjustment value of OFFSET-RGB1 by 3. OFFSET mode: Select RGB 1 mode with the top and bottom keys. MAT CONT : "1" key Increase the adjustment value by 3 with the right and left keys. Increase the MAT BRIGHT adjustment value of OFFSET-RGB1 by 2. OFFSET mode: Select RGB 1 mode with the top and bottom keys. MAT BRIGHT : "2" key Increase the adjustment value by 2 with the right and left keys. Turn the ACL SW setting to ON. INITIALIZE mode ACL SW : "3" key Select ON with the right and left keys. Input a RGB (PC) signal to the INPUT1 or INPUT2. Use a signal consisting of the luminance signal only, such as a ramp signal or STEP signal, whose black level (0IRE) and gradation can be checked. � Recommended signal: VESA VGA@60Hz
16
1
D
2 3 4 RGB (PC) signal 5
Set the unit to Standby mode then to Factory mode. MENU � SET � POWER ON Take a trigger of the oscilloscope with HD_PLL (3.3Vp-p) of K4805. Measure the signal waveform of the Green signal at K4603, and measure the black level (0IRE) and amplitude. AD R LOW adjustment Measure the black level (0IRE) of the Red signal at K4602, and adjust the level of AD R LOW so that its black level (0IRE) becomes the same as that of the Green signal measured in step 9. Tolerance: ± 0.05V OFFSET mode: Select RGB 1 mode with the top and bottom keys. AD R LOW : "9" key Adjust with the right and left keys.
E
6
AD R HIGH adjustment Measure the signal amplitude of the Red signal at K4602, and adjust the level of AD R HIGH so that its signal amplitude becomes the same as that of the Green signal measured in step 9. Tolerance: ± 0.05V OFFSET mode: Select RGB 1 mode with the top and bottom keys. AD R HIGH : "6" key Adjust with the right and left keys.
F
140
1 2
PRO-800HDI
3 4
|
|
|
> |
|
